Sony NSR-500 Series Installation Manual page 14

G NETWORK LEDs (1 and 2)
Light green when there is a link to the
network.
Blink amber when the network is being
accessed.
H
USB connectors (1 and 2)
Use this connector to connect a USB
mouse, keyboard, USB flash memory,
or system controller (RM-NS1000) to
the unit.
I REC LED
Lights red when recording images.
J STATUS LED
Indicates the recognition status of USB
flash memory devices.
If a device is recognized, this lights
green.
If a device is not recognized, this lights
red.
Caution
Do not remove the USB flash memory
device while the LED is blinking.
K FAN LED
Lights green when the internal fan is
functioning properly. Lights red when a
fan failure occurs.
L SYSTEM LED
Blinks green while the unit is starting up
and then changes to always on when the
unit has started.
During operation, this LED is lit green
when the system is functioning
normally. When a system error or other
problem occurs, it lights red.
If this LED is lit red, contact your Sony
dealer.
14 Features and Functions
M Power switch
Press this to turn on the unit.
If you press the power switch during
operation, the POWER LED blinks
green for up to 3 seconds.
Pressing the power switch again during
this time turns off the unit.
If 3 seconds elapse without the power
switch being pressed while the POWER
LED is blinking, the unit does not turn
off and operation continues.
Caution
Pressing and holding down the power
switch (approximately 5 seconds) turns
off the unit forcefully.
N POWER LED
Lights green when the unit is turned on.
If you press the power switch during
operation, the POWER LED blinks
green for up to 3 seconds.