Using The Smartnav - Picomed NaturalPoint SmartNav 4 Manual

NaturalPoint SmartNAV Users Manual : Getting Started
Follow these steps for mounting the SmartNAV on flat panel and laptop displays :
1. Twist the thumbscrew to loosen the small leg at the back of the SmartNAV.
2. Set the SmartNAV on the display with its front legs flush. Push the small rear leg in until it
touches the monitor, then re-tighten the thumbscrew.
3. Note that the small back clamping leg can slide in and out as well as rotate.

3 Using the SmartNav

3.1 Head Control How-To
3.1.1 How it works
The SmartNav works by tracking infrared light reflected off the dot on your forehead, glasses, headset or
TrackHAT.
3.1.2 Set-up
1. Put on the TrackHAT or peel a dot from the sheet and place it on your forehead, bridge of your
glasses, or headset microphone, etc.
2. Place the SmartNav unit on top of your monitor or clip to the top of your laptop screen.
3. Make sure the SmartNav unit is plugged in and the software is running.
4. Aim the SmartNav unit at your head.
5. First time users should select a slow to medium profile.
7/41
07/03/2008 03:35:45 PM