Hardware Installation - Picomed NaturalPoint SmartNav 4 Manual

NaturalPoint SmartNAV Users Manual : Getting Started

2.3.5 Hardware Installation

1. If your monitor is too far away from your computer for the SmartNav's USB cable to reach,
simply unplug the SmartNav device, plug the USB extension cable into your computer's USB
port, and plug the SmartNav into the extension cable's female connector.
2. Your computer may briefly display a message indicating that it is installing the drivers for the
SmartNav.
3. Double click on the newly created NaturalPoint icon on your desktop to open the SmartNav
software program.
4. Remove a dot from the sheet included with your SmartNav unit and place it on the tip of your
index finger. With the dot facing the SmartNav unit, slowly move your finger back and forth in
front of the SmartNav unit from about an arms length away. If the green indicator light comes on
and the cursor moves along with your finger, you have installed the SmartNav unit and software
correctly. If the green indicator light does not come on or the cursor does not move, please consult
the trouble shooting guide at the back of this manual.
2.3.6 Voice Clicking Installation
The SmartNAV Software features built in voice recognition for command and control.
For available commands, please see section 3.1.6 (Voice Clicking)
If you purchased the SmartNAV Voice Clicking accessory CD, then you may install the voice recognition
package from the CD.
Insert the SmartNAV CD into your CD-Rom. You may be prompted to uninstall any previous versions,
follow the prompts as necessary to uninstall any older versions and run through the standard install
procedure. Once setup is complete the software will prompt you: 'Would you like to install Voice
Recognition Support for SmartNAV', click yes to proceed. This will launch the installer for the voice
clicking software, please follow the prompts to install the software.
5/41
07/03/2008 03:35:45 PM