Software Installation - Picomed NaturalPoint SmartNav 4 Manual

NaturalPoint SmartNAV Users Manual : Getting Started
Microphone or headset
◊
◊ SmartNAV Software Version 3.20.028 or higher with Speech Support installer
2.2 What Is Included
1 SmartNav
26 Dots
Software CD
2.3 Installation
Install the SmartNav Software BEFORE you connect the SmartNav unit!
2.3.1 Hint for XP users
It is recommended that before installing any new hardware or software program that you set a system
restore point. XP provides this feature to allow you to reset your system to a previous state very easily.
After the software is installed and everything is working fine, set another restore point. Users that get into
the habit of using this feature find they have fewer problems on their computers. The System Restore
program can be found by clicking: Start/Programs/Accessories/System Tools/System Restore

2.3.2 Software Installation

NOTE: Windows 2000 and XP users must be logged in as an administrator. If you only have one user set
up on your computer, you most likely already have administrator privileges.
1. Insert the included NaturalPoint software CD into your computer's CD drive. Wait for the install
program to start. If the install program does not start within a few minutes, double click on the CD
Y-Split Adapter for Switch Input
(AT and EG models only)
3/41
07/03/2008 03:35:45 PM