Advertisement
THE LIBRA-DXK4RF SERIES KEYPAD
DESCRIPTION
The LIBRA-DXK4RF series keypad is a multi-segment LCD digital keypad that is compatible with the LIBRA LIB-
P432EX, LIB-P432EXT, LIB-P432EXT-230 control panels.
instructions. While the LIBRA-DXK4RF series keypads may be used to fully program the control panel, the
GEM-DXRP1 or GEM-DXK1 keypads, with their easy to read two-line LCD displays, provide the optimum in
ease of keypad programming. Note: Do not mix "RP" series keypads with "K Series" keypads within one system.
The wireless system comprises a compatible LIBRA LIB-P432EX series control panel, at least one LIBRA-RECV re-
ceiver and one or more companion LIBRA-Series transmitters. Built inside the LIBRA-DXK4RF series keypad is a re-
ceiver to save space and simplify installation. The transmitters may be wireless smoke detectors, space-protection de-
vices, window/door sensors, or other devices that report zone status and supervision information to the receiver with-
out the use of wires.
The integral receiver inside the keypad will accommodate up to 32 wireless points. The receiver is connected to the
control panel's 4-wire bus through the same 4 wires as the keypad. The receiver monitors each transmitter, updating
transmitter status as reports are received, and conveys this information to the control panel. Also monitored is the
elapsed time since the last report from each transmitter. If no report is received within a programmed time, a Supervi-
sory Failure will result.
COMPATIBLE CONTROL PANELS
See WI1752 for installation and programming instructions with the GEM-P816, GEM-P1632, GEM-P3200 and GEM-
P9600 control panels.
SPECIFICATIONS
Operating Voltage: 12VDC (supplied by panel)
Current Drain: 75 mA Standby
Note: Subtract keypad current from combined auxiliary current of the control panel.
Operating Temperature: 0° C to 49° C
Storage Temperature: 20° C to + 85° C
Power Requirements: 12VDC, 75mA (supplied by panel)
Antenna: ¼-wave (external wire), and internal antennas.
Dimensions: 5 7/8" x 4 3/8" x 1" (WxHxD)
ORDERING INFORMATION
Note: Any of the following Napco wireless transmitters may be used with the LIBRA-RECV Series Receivers. Bat-
teries are included with all transmitters.
LIBRA-TRANS433 - Window/Door Sensor. This supervised, two-point transmitter provides an internal magnetic reed
switch and/or terminals for two external normally-closed devices, or one external normally-open device.
LIBRA-PIR433 - Wireless PIR Motion Sensor.
LIBRA-SMK433 - Wireless Photoelectric Supervised smoke detector.
LIBRA-KEYF433 - Hand-Held Keyfob Transmitter. Key chain/Pendant remote arming or emergency transmitter.
LIBRA-GB433 - Glass-break sensor.
DL123A - Replacement Lithium Battery for LIBRA-TRANS433, LIBRA-PIR433 (2), and LIBRA-GB433 (2) (bulk
packed).
LIBRA-RECV8-433: Wireless Receiver, 8 Zones
LIBRA-RECV16-433: Wireless Receiver, 16 Zones
LIBRA-RECV96-433: Wireless Receiver, 96 Zones (maximum 32 zones supported)
LIBRA-RECV255-433: Wireless Receiver, 255 Zones (maximum 32 zones supported)
2
Refer to User Guide OI349 for keypad operation
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
Advertisement
