Torques - JAWA Dandy MJ50 Operation And Maintenance Manual

Work Description and Scope
Clutch and its adjustment
Check its function and adjust or replace it, if need be.
(See Section 3.11.)
Telescopic fork
Functional check or replacement, if need be.
(See Section. 8.21.)
Steering bearings
Check and replacement, if need be.
(See Section 8.22.)
Wheel bearings
They require no maintenance. If there is a clearance
in the bearings, replace them. Have them replaced
in a special service. (See Section 8.23.)

8.2. Torques

Use a torque wrench for tightening the screws and nuts. It is recommended to make occassionaly the check of
tightening, especially before a long drive. Check always torques at mounting or dismantling individual parts.
Torque Tables
Engine drain plug
Sparking plug
Front wheel axle nut
Front wheel axle socket screw
Rear wheel axle nuts
Swinging fork axle nut
Lower beam screw
Upper beam screws
Engine bearing
Socket screw M8x53
Socket screw - M8x100
Before
Putting
into
Operation
Screw
M 6 mm
M 8 mm
M 10 mm
M 12 mm
M 14 nun
M 16 mm
20-25 N.m Rear brake lever screw
15-20 N.m Central springing unit
35-40 N.m screws
15-20 N.m Brake braket screws
50-60 N.m upper
30-35 N.m lower
20-25 N.m Handlebars Yoke screws
15-20 N.m Brake hose screws
Cylinder head nuts
10-15 N.m Exhaust flange bolts
25-30 N.m Screws for plastic
17
After
every 3,000 km 6,000 km
1,000 kni
Torque
8-12 N.m
18-28 N.m
40-60 N.m
70-100 N.m
110-160 N. m
170-250 N.m
In Case of
Need
x
x
x
x
6-10 N.m
35-40 N.m
20-25 N.m
14-15 N.m
15-20 N.m
17-18 N.m
10-12 N.m
10-15 N.m
3.5 - 4 N.m