Table of Contents
Advertisement
GBC 4064WF
Figure 12
Figure 13
Figure 14
Figure 15
© 2005 General Binding Corporation
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Swing around control panel arm:
A
(Fig. 12 – Item A)
The Control panel is on a swing around arm
B
which will allow the operator to move the
necessary control to each side of the machine.
Control Panel: (Fig. 12 – Item B)
The Control panel has most the machine
controls to operate the machine.
Nip Pressure Adjustment:
(Fig. 13 – Item A)
A
The Nip pressure adjustment is a pneumatic
air regulator and a gauge that allows the
operator to adjust the downward pressure of
the pull rolls and main rolls.
A
Electronic Safety Beam: (Fig.14-Item A and
Fig. 15–Item A)
A
Safety light beam is used to protect the Nip
area with out being in the way of normal
lamination
operation.
following chart for sequence of operations:
Operation Manual
Please
see
the
Page 13
Advertisement
Table of Contents
