Table of Contents
Advertisement
GBC 4064WF
CONTROL GUIDE
1
2
13
12
10
11
© 2005 General Binding Corporation
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
A. Power ON/OFF (I/O):
Located at the back left of the machine applies power to the
laminator. The control panel display will illuminate when
3
position marked "I" is pushed. The Off position, marked "O"
removes power from the laminator.
B. Control Panel (Figure 5)
a
1. LCD Display:
4
Displays-Time in minutes and seconds and material used in Feet
(For North America), Meters (For All Other Areas)
2. Display Reset Switch:
Resets the LCD Display reading to zero.
5
3. Top Roll Display
• Displays Temperature in "
b
• LED Marked "
• LED Marked "
7
• LED Marked "Ready" illuminates when set temperature is
{a}. Control Switches
∧ - When pressed increases the Temperature
∨ When pressed decreases the Temperature
MEAS-Press and Hold to Display Current Bottom Roller
Temperature.
4. Main Switch (TOP Heater):
9
8
5. Bottom Roll Display
•
•
•
•
6. Main Switch (Bottom Heater):
position turns On the bottom heater, when pressed to the
position turns Off the bottom heater.
7. Fan Switch:
8. Main Roller (Up/Down): (
movement of Main Roller through pneumatics.
9. Pull Roller (Up/Down): (
movement of Pull Roller through pneumatics.
10. Machine Power On Light:
Machine On.
11. Laminator Main Control Switch:
laminator between "RUN" and "STOP"
12. Laminator Direction Motion Control Switch: Controls
the forward and rearward movement of the laminator.
13. Laminator Speed Control:
Regulates the speed of laminator feed.
•
•
Operation Manual
o
C "or "
(Both Set Temperature and Current Temperature, when
MEAS switch is pressed).
o
C", if Illuminated, indicates reading in "
"
o
F", if Illuminated, indicates Temperature
o
reading in "
F"
reached.
When pressed to the
position turns On the top heater, when pressed to the
position turns Off the top heater.
o
Displays Temperature in "
C" or "
Heater. (Both Set Temperature and Current
Temperature, when MEAS switch is pressed)
o
LED Marked "
C", if illuminated, indicates reading in "
o
LED Marked "
F", if Illuminated, indicates Temperature
o
reading in "
F".
LED Marked "READY" illuminates when set temperature is
reached.
Switches cooling fan ON
Outer Scale in Feet/Minute
Inner Scale in M/Minute
o
F" of the Top Heater
o
C
o
F" of the Bottom
o
C".
When pressed to the
/OFF
) Controls Up/Down
) Controls Up/Down
Green light illuminated-
Switches the
modes.
Page 7
Advertisement
Table of Contents
