Wheel Rims; Spare Tire - Hobby Van Exclusive Manual

04-3
Wheels, tyres, brakes

4.5 Wheel rims

Use only those wheel rims listed in the vehicle's documents.
Please observe the following points, should you wish to use
other wheel rims.
The following applies when using other wheel rims:
- Size,
- construction,
- injection depth and
- The load bearing capacity must be sufficient for the per-
missible total axle weight.
- The cone of the fastening screw must correspond to the
construction of the wheel rim.
Adaptations are only permitted if these have been released by
the manufacturer.
Aluminium wheel rims must be tested separately for each type
of vehicle. The screws used on aluminium rims may not be
used for steel rims.
Spare tire on the AL-KO chassis

4.6 Spare tire

A spare tire is part of the scope of delivery only for tan-
dem axle vehicles with an AL-KO chassis (D 75) and the
Sphinx models.
To remove the spare tire on the AL-KO chassis, use a he-
xagon spanner to remove the two screws on the spare tire
holder. Insert the crank on the left-hand side of the spare
tire holder, unhinge the tire holder, lower the spare tire to the
ground and remove it.
For information on the Iveco spare tire, please refer to the
operating instructions for the base vehicle.