Finger Columnating Plate Identification - Lincoln Foodservice Impinger Series 1600 Operator's Manual

ASSEMBLY INSTRUCTIONS (CONT'D)
6. Assemble Fingers as shown to the right.
Insert columnating plate so the step goes under the lip of the
finger housing and the plate lies flush with the housing side
edge.
Install cover by sliding it on the small end of the finger
housing.
7. To install close-off plates, use close-off plate as a template
and drill three (3) mounting holes. Use #29 drill. Use
three (3) screws supplied to mount close-off plate.
There are two styles of finger housings. Four (4) rights
and four (4) lefts. The plenum has openings which dictate
which style is used. Check each finger housing "Style" to
determine which plenum opening will accept it.
Install assembled finger through door opening starting with
lower left.
Install fingers in the oven by sliding it over the plenum
flange and setting the front of the finger on the retaining
bracket. Be sure that the finger sets squarely over the
plenum flanges and the holes point in the proper direction.
Top fingers point down, bottom fingers point up. Repeat
until all eight (8) fingers are installed.
Low Profile – 1600 Series Operator Manual – Dom & Int'l
Assembly instructions continued on next page.
NOTE: The customer MUST tell you what position to
place the assembled fingers in, for their application.
13