Carl Valentin VARIO III series Service Instructions Manual page 46

Error correction
Error message
82 Time generation
83 Transport protection
84 No font data
85 No layout ID
86 Layout ID
87 RFID no label
88 RFID verify
89 RFID timeout
90 RFID data
91 RFID tag type
92 RFID lock
93 RFID programming
94 Scanner timeout
46
Cause
Printing creation was still active
at print start.
Both DPM position sensors
(start/end) are active.
Font and web data is missing.
Label ID definition is missing.
Scanned data does not
correspond to defined ID.
RFID unit cannot recognise a
label.
Error while checking
programmed data.
Error at programming the RFID
label.
Faulty or incomplete definition
of RFID data.
Definition of label data does not
correspond with the used label.
Error at programming the RFID
label (locked fields).
Error at programming the RFID
label.
The scanner could not read the
bar code within the set timeout
time.
Defective printhead.
Wrinkles in transfer ribbon.
Scanner wrong positioned.
Timeout time too short.
Service Instructions
Vario III Series
Remedy
Reduce print speed.
Use printers' output signal for
synchronisation.
Use bitmap fonts to reduce
generating time.
Displace zero point sensor
Check sensors in service
functions menu
Run a software update.
Define label ID onto the label.
Wrong label loaded from CF
card.
Displace RFID unit or use an
offset.
Faulty RFID label.
Check RFID definitions
Label positioning.
Faulty label.
Check RFID data definitions.
Check storage partitioning of
used label type
Check RFID data definitions.
Label was already
programmed.
Check RFID definitions.
Check printhead.
Check transfer ribbon.
Position scanner correctly,
corresponding to the set
feeding.
Select longer timeout time.
03.14