Quick Start - Team Losi LOSB0290 1/10 Slider RTR User Manual

Note: Please read the entire manual to gain a full understanding of the 1/10 Slider
vehicle, fine-tuning the setup and performing maintenance.
 1. Read the safety precautions found on page 3. This is important for your safety and
prevention of personal injury.
 2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the
manufacturer's supplied instructions for battery charging information.
 3. Install the AA batteries into the LSR-3000 transmitter (see page 9). Use alkaline or
rechargeable batteries only.
 4. Install the battery pack (see previous page). The battery pack should be fully charged
before installation.
 5. Turn on the transmitter and then the vehicle. It is a good practice to
turn on the transmitter before the vehicle and turn it off after the vehicle has
been turned off.
 6. Check steering (see page 12). Verify that the servo is functioning properly.
 7. Driving the 1/10 Slider (see page 14).
 8. Performing maintenance of the 1/10 Slider. Refer to Tuning, Adjusting and
Maintenance of the 1/10 Slider on page 15.

Quick Start


TM