Safety Precautions; Battery/Charging - Team Losi LOSB0290 1/10 Slider RTR User Manual

Safety Precautions

We hope you operate this RC model in a safe, reasonable
and cautious fashion in order to enjoy your vehicle. Should
you operate this vehicle without a cautious and reasonable
approach it may result in serious injury and/or property
damage. Only you can control and make certain that safety
precautions and instructions are followed.
General:
• The 1/10 Slider is not a toy. This product is not intended for
use by children without direct adult supervision.
• This RC vehicle is not intended for use on public highways
or roads.
• Avoid an area that has many pedestrians or crowds
of people.
• Keep in mind that this vehicle is radio controlled and
can experience moments of radio loss or interference, so
provide for a margin of error at all times.
• Please be aware that the motor and batteries of this
RC vehicle will get HOT during each use. Be careful not
to burn yourself.
Electronic Speed Control (ESC):
• Read all safety precautions prior to each use.
• Never leave the vehicle/ESC unsupervised while it is
switched on, in use or connected to a power source. If
there is a short-circuit or product defect, it could result in
re.
• If there are exposed wires, do not use the ESC until you
have installed shrink-wrap or replaced the wire.
• Disconnect the battery from the ESC after use.
• The ESC is not waterproof and should not be exposed
to moisture.
This ESC does not contain voltage cut-o circuitry.
•
Do not attempt to use a 2S 7.4V LiPo; doing so may
damage the battery and could result in re.
• Always turn on the transmitter rst then the ESC to
prevent an out-of-control vehicle.
• When setting your Electronic Speed Controller:
º Please disconnect motor or remove the pinion gear
during ESC setup or calibration functions.
º Keep loose clothing, hair, gloves and ngers away
from moving parts at all times.
º Rubber tires can cause severe injury if there is a
failure while running the vehicle while on a stand or
when being held. Ensure rubber tires are securely
mounted to the rims and if not, re-glue them and
check them often for security.
Batteries and Charging:
The 1/10 Slider uses rechargeable batteries such as NiMH or
NiCd. These batteries require special handling to preserve
performance and last a long time. Read all instructions and
precautions that are provided with the batteries intended to
be used in the 1/10 Slider.
• Read all instructions provided by the manufacturer
of the batteries.
• Responsible adult supervision is necessary while
charging batteries.
• Always check to ensure the polarity of battery
connection is correct.
• Never leave batteries unattended while charging.
• Never charge a battery while it is installed in the 1/10
Slider.
• Do not charge any battery that appears to have
any damage.
• If there are exposed wires do not charge or use the
battery until you have installed shrink-wrap or replaced
the complete wire.
When charging NiMH batteries, select a charger to meet
your requirements. Chargers can be of two primary types
for their source of power; a 100-240V wall charger, or one
which requires a 12V power supply. Follow the charger
manufacturer's instructions and precautions during each use.
TM