Team Losi LOS01008 Instruction Manual

BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally
Unique Identifi er) code of a single specifi c transmitter.
Power off the transmitter and ESC.
1.
Connect a fully charged battery pack to the ESC.
2.
Press and hold the bind button on Receiver while powering up the ESC. After 2
3.
seconds the receiver will be in bind mode.
Release the bind button and power on transmitter.
4.
Binding is complete when the light stops blinking on receiver .
5.
You must rebind when binding the receiver to a different transmitter.
NOTICE: Do not attempt to bind the transmitter and receiver if there are other
compatible transmitters in bind mode within 400 feet. Doing so may result in
unexpected binding.
CONTROL TEST
Perform a control test with the vehicle wheels off the ground. If the wheels rotate
after the vehicle is powered ON, adjust the TH Trim knob until they stop. To make
the wheels move forward, pull the trigger. To reverse them, wait for the wheels to
stop, then push the trigger. When moving forward, the wheels should maintain a
straight line without any steering wheel input. If not, adjust the ST Trim knob, so
the wheels maintain a straight line without having to turn the steering wheel.
DRIVING PRECAUTIONS
• Maintain sight of the vehicle at all times.
• Inspect the vehicle for loose wheel hardware.
• Inspect the steering assembly for any loose hardware. Driving the vehicle off-
road can cause fasteners to loosen over time.
• Do not drive the vehicle in tall grass. Doing so can damage the vehicle or
electronics.
• Stop driving the vehicle when you notice a lack of power. Driving the vehicle
when the battery is discharged can cause the receiver to power off. You may
lose control of the vehicle.
• Do not apply the throttle in forward or reverse if the vehicle is stuck. Applying
throttle in this instance can damage the motor or ESC.
• After driving the vehicle, allow the electronics to cool to ambient temperature
before using the next battery pack.
LOSI 1/14 MINI RALLY 4WD RTR • INSTRUCTION MANUAL
1/14 MINI RALLY 4WD RTR–LOS01008
Exploded View/Explosionszeichnung/Vue éclatée/Vista Esplosa
Parts Listings/Teileliste/Liste des pièces/Elenco componenti
FAILSAFE
Failsafe positions are set during binding. In the unlikely event that the radio link
is lost during use, the receiver will hold the steering at the last command with
no throttle. If the receiver is powered on before powering on the transmitter, the
receiver will enter failsafe mode. When the transmitter is powered on, normal
control is resumed.
49399 800-0522
1