Table of Contents
Advertisement
5 SETTING OF THE FUNCTION MENU SWITCHES
5-2 Contents of the Function Menu Switches
[
]: Factory setting
Screens
Items
VTR mode 2
COUNT END
setting
Alarm/sensor
ALARM REC
recording mode
setting
SENSOR REC
DURATION
BUZZER
TAPE END
MODE
RS-232C
This screen is displayed on the on-screen mode setting screen only when the (optional) RS-232C
parameter
board SA-K97U is installed.
setting
BAUD RATE
22
Set values
[OFF]
Sets the timing to process tape end at a specified counter value rather than at
500
the actual tape end. This menu switch setting is effective in the 48H to 240H
1000
Record modes. For the 3H to L24H modes, set with <REC REMAIN>. The
:
following operations are executed at the timing set with this menu switch.
:
• The tape end signal is output from the rear panel's [TAPE END] terminal.
9500
• The series recording signal is output from the rear panel's [CLOCK/SERIES
OUT] terminal (with the TERMINAL SEL 1> function menu switch set to
"SERIES").
• The tape end buzzer sounds (with the <TAPE END BUZZER> function menu
switch set to "ON").
• "End" is shown on the counter display.
OFF: Executes tape end processing at the actual tape end.
5000 - 9500: Executes tape end processing at the set tape counter value.
To determine the set tape counter value according to the tape length, refer to
the table on page 53.
[OFF]
Turns the alarm recording function on or off.
ON
Alarm recording is enabled only in the Timelapse Record mode.
An index code (VISS signal) is also recorded at the start point of alarm
recording as an alarm cue signal.
OFF : Alarm recording is disabled.
ON : This unit enters the VHS SP Record mode, when an alarm signal is input
to the rear panel's [ALARM IN] terminal during timelapse recording.
[OFF]
Turns the sensor recording function on or off. Sensor recording is enabled in
the Stop mode. An index code (VISS signal) is also recorded at the start point of
ON
sensor recording.
OFF : Sensor recording is disabled.
ON : When an alarm signal is input to the rear panel's [ALARM IN] terminal in
the Stop mode. this unit automatically starts recording in the VHS SP
Recrd mode.
5
Selects the recording duration for alarm recording or sensor recording.
15
5 ..... 180 : Alarm or sensor recording is performed for the time specified (5 sec.
30
to 180 sec.).
60
TAPE END: Alarm or sensor recording continues until the tape ends.
120
MANUAL : Alarm or sensor recording continues for as long as alarm signals
[180]
are input.
TAPE END
Set to this position when specifying the alarm recording time with a
MANUAL
switcher.
[OFF]
Selects whether or not the alarm buzzer sounds during alarm or sensor
ON
recording.
OFF : The buzzer does not sound.
ON : The buzzer sounds.
[STOP]
Set the operation mode at tape end during recording in the case when alarm or
REW
sensor recording is executed even once.
REPEAT
STOP
: Stops at tape end.
EJECT
REW
: Rewinds the tape automatically and stops.
REPEAT : Rewinds the tape automatically to the beginning and restarts
recording.
EJECT
: The tape is ejected.
Select the RS-232C data transfer speed from 1200 bps, 2400 bps, 4800 bps or
1200
9600 bps.
2400
4800
[9600]
Function
Advertisement
Table of Contents
