Recording Features; Record One Program While Watching Another; Display Elapsed Recording Time; Display Tape Remaining Time - JVC Model HR-DVS1U Instructions Manual

36
EN
Recording
Features
C.RESET
1
REW
MENU
Record One Program While
Watching Another
ENGAGE TV MODE
1
During recording...
Change the TV's input mode from AV to TV.
SELECT CHANNEL FOR
VIEWING
2
Use the TV's channel selector to set the channel you
want to watch.
PLAYBACK AND RECORDING FEATURES (cont.)
DISPLAY
T W
1 2 3
2
4 5 6
7 8 9
0
4
DV VHS
FF
PAUSE
Display Elapsed Recording
Time
(VHS deck only)
RESET COUNTER TO ZERO
1
Before recording starts, press C.RESET. The counter
resets to zero and displays the exact elapsed time as the
tape runs.
DISPLAY ELAPSED TIME ON
SCREEN
2
During recording, press DISPLAY at any time to see the
elapsed time.
All indications corresponding to the current status of the
VCR are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
Press DISPLAY again to remove the display.
Make sure "SUPERIMPOSE" is set to "ON" (
The indications are not recorded.
Press DISPLAY to change to the COUNT display if
"REMAIN" is displayed.

Display Tape Remaining Time

(VHS deck only)
DISPLAY COUNTER
INFORMATION
1
Press DISPLAY.
All indications corresponding to the VCR's current
status are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
DISPLAY TAPE REMAINING
TIME
2
Press DISPLAY repeatedly until "REMAIN" appears on
screen. The approximate tape remaining time appears
on the TV screen and also on the VCR display panel
with a " " indicator.
The tape remaining time is calculated based on the
tape speed (SP or EP) being used. The indicated
remaining time is only an estimate.
Press DISPLAY to change the on-screen display from
"REMAIN" to "COUNT" and vice versa; and to show
counter reading, channel number, clock time or tape
remaining time on the front display panel. Then
channel number will not be displayed when the VCR
is playing a tape.
EXIT THE DISPLAY
3
Press DISPLAY again.
NOTES:
"SUPERIMPOSE" must be set to "ON", or the on-screen
display will not appear (
Near the beginning of the tape, the tape remaining estimate
may be inaccurate. However, the estimate becomes more
accurate as the tape comes closer to the end.
Depending on the type of tape used, the tape remaining time
reading may not appear right away, or may not be correct. "- -:- -"
may sometimes appear, or the display may blink on occasion.
The tape remaining time indication is not accurate when
using VHS-C tapes with VHS-C adapter.
pg. 25).
pg. 25).