Adjusting The Ringer Tone Sequence; Setting The Tone Ringing Melody - Siemens HA 8000 (22) P/T SD Illustration Manual

Basic settings

Adjusting the ringer tone sequence

You can adjust the ringer tone sequence in 4 stages, the tone sequence is
preset to stage 4.
Lift the handset
Press the SET key
Then press key 6, the ringer sounds so that you can check it
E.g. if you press key 3
Press the SET key to confirm your setting. This saves the setting.
Notes:
All settings which are begun with the SET key must also be terminated with
the same key. Only then will the desired settings be stored.
Therefore, if you do not press SET key at the end of an adjustment, any
settings or changes made will not be saved. The original settings remain in
effect. You can abort a procedure simply by replacing the handset.
Instead of lifting the handset, you can also press the SPEAKER key.

Setting the tone ringing melody

10 different melodies can be set for tone ringing (factory setting: melody 0).
Lift the handset
Then start the function, you will hear the ringing
Press one of the key 0...9
Press SET key
Replace the handset
8