Table of Contents
Advertisement
A
D
Slide
Button "B"
Recessed side
of wheel
Axle Pin
(Button End)
KidWalk
**Note:
must be used with it's Anti-Tippers or Cruiser Wheels at all times. **
**Note: Do NOT remove the Anti-Tippers or use the
Wheels at any time.**
KidWalk
Owner's Manual
B
C
E
Fig. 1
Fig. 2
Button "A"
Fig. 3
7
ASSEMBLY INSTRUCTIONS
Set-up and assembly on your
when these directions are followed.
First:
Open carton, remove and identify the following
assemblies and components.
A Base frame assembly (with)
B Anti-tippers
C Mast assembly
D Wheels (2)
E Bag containing axles and spacers
(2 spacers for use with mag wheels only)
(4 spacers for use on Spoke wheels only)
Any optional accessories (if ordered)
Assembly Procedure:
1. Place base frame on flat surface and install
anti-tippers into frame, as shown in Fig 1.
2. Adjust the anti-tippers for wheel placement
on the base frame by depressing the posi-
tion setting push button "A" and slide until
locking button is in the middle position as
shown. (fig. 2) To remove the anti tippers
both button "A" and button "B" will need to
be depressed.
Mag Wheels (Standard)
3. Remove axles from plastic bag. Insert
an axle into a wheel from the recessed
bearing side (fig. 3), push in button at
end of axle to allow the axle to slide
through the wheel bearings and insert
....axle into wheel. Assemble 1 spacer onto
each axle on the back of the wheel after the
axle is inserted. Go to step 4.
Spoke Wheels (Optional)
Remove axles and axles spacers from plastic bag.
Insert one spacer onto an axle before inserting
it into the wheel and then insert the axle into
the wheel hub from the recessed bearing side (fig.
3). Push in the button at end of axle to allow the axle
to slide through the wheel bearings and add one
spacer onto the back of the axle after the axle is
inserted into the wheel. Spoke wheels must be
used with both spacers in place on each
axle. Go to step 4.
KidWalk
without Anti-Tippers or the Cruiser
KidWalk
is easy
Advertisement
Table of Contents
