Measurements & Initial Setup Information - Prime Engineering KidWalk Owner's Manual

Height Adjust /
Release Handle
T-Handle
Entry Position:
Note: Never leave a client unattended while using the
KidWalk
Owner's Manual
MEASUREMENTS & INITIAL SETUP
Measurements:
The following measurements should be taken
and recorded to properly setup the

Inseam

Hip Width

Chest Width
Fine Tune

Thoracic Height*

Head Height*
*Thoracic height and head height measurements should
be taken from the top of the inseam. These dimensions
are needed to setup KidWalk optional Lateral Chest
System and/or Headpad and Headrests.
Fig. 9
KidWalk
Seat Height

Using the Height Adjust / Release Handle or the
Fine Adjustment Handle (fig. 9), adjust the seat
height to about equal with the inside leg
measurement.

To raise the seat assembly with the Height Adjust /
Release Handle, press down on the top of the mast
while lifting up on the Height Adjust / Release Handle.

To raise the seat using the Fine Adjustment,
place your hand in the handle and squeeze the
Lower Fine Tune handle (fig. 9). Each time you fully
activate the Fine Tune handle the seat will rise up
approximately 1/2 inch.

To lower the seat, lift up on the T-handle to
release any weight from the seat assembly and
press slightly downward on the Height Adjust/
Fig. 10
Release Handle (fig. 9). Only minimal pressure is
needed to lower the seat down the mast. Do not
push too hard. Releasing the Height Adjust/
Release Handle will stop the seat from lowering.
For safety reasons,
cannot be lowered while there is weight on
the seat.
Other Items:
Make sure that all of the Support pads are high enough
and opened wide enough to allow the client to initially
easily fit within them. Adjust any optional items per the
instructions included with the item.
11
KidWalk:
__________
__________
__________
__________
__________
Initial Adjustments:
KidWalk
seat height
KidWalk.