Basic Recording - JVC HR-VP78U Instructions Manual

Basic
Recording
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
POWER
POWER
MENU
VIDEO (MONO)L—AUDIO—R
OK
TV/VCR
1
4
7
1
REW ( 1 )
4
This VCR can check the tape condition during recording
(and playback), and realizes the best possible pictures.
Load a cassette
1
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
SHUTTLE ring
PLAY ( # )
4
REW
PLAY
SP EP
CH
VCR REC
SP/EP
2 3
STOP/EJECT
( 7 / 0 )
PAUSE ( 8 )
POWER
2 3
2
5 6
b
–
2
8 9
0
4
a
–
2
3
FF ( ¡ )
PAUSE ( 8 )
STOP ( 7 )
Select recording channel
2
On the front panel:
Press CH 5∞.
On the Remote:
a– Press CH + or –.
b– Press the Number keys.
If you connect the TV and the VCR only using
the RF connection, press TV/VCR on the Remote
so that the VCR mode indicator lights on the front
display panel, to view the program to be recorded.
Set tape speed
3
Press SP/EP to set the recording speed.
FF
Start recording
4
On the front panel:
STOP/EJECT PAUSE
Press REC ( ¶ ).
On the Remote:
While holding REC ( ¶ ), press PLAY ( 3 ).
If "VIDEO CALIBRATION" is set to "ON"
(default setting:
the tape condition for about seven seconds,
then starts recording. This means that the first
seven seconds of the program will not be
recorded. If this is inconvenient for you, follow
the steps below:
1
2
To pause recording
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
To stop recording
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when the tape is not running)
Press REW ( 1 ) (or turn the SHUTTLE ring on the front
panel to the left).
To fast-forward the tape (when the tape is not running)
Press FF ( ¡ ) (or turn the SHUTTLE ring on the front
panel to the right).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
You can also eject the cassette with the VCR turned off.
To turn off the VCR
Press POWER.
or
pg. 38, 39), this VCR checks
Press REC ( ¶ ) and PAUSE ( 8 ) to start
Video Calibration.
Then press PLAY ( 3 ) to start recording
after Video Calibration is complete.
25
EN