Basic Recording - JVC HR-S8007UM Instructions Manual

Basic
Recording
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
TV/VCR
1
REW ( 1 )
4
Accidental erasure prevention
To prevent accidental
recording on a recorded
cassette, remove its record
safety tab.
To record on it later, cover
the hole with adhesive tape.
Downloaded from: https://www.usersmanualguide.com/
PLAY ( 3 )
2
4
STOP/EJECT
( 7 / 0 )
1 2 3
2
2
4 5 6
7 8 9
4
0
2
3
FF ( ¡ )
PAUSE ( 8 )
STOP ( 7 )
Record safety tab
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
2
Select recording channel
On the front panel:
Press CH5∞.
On the Remote:
a– Press PR + or –.
SHUTTLE
ring b– Press the Number keys.
● If you connect the TV and the VCR only using
the RF connection, press TV/VCR on the Remote
so that the VCR mode indicator lights on the front
display panel, to view the program to be recorded.
3
Set tape speed
On the Remote ONLY:
Press
4
Start recording
On the front panel:
Press REC ( ¶ ).
On the Remote:
While holding REC ( ¶ ), press PLAY ( 3 ).
PAUSE ( 8 )
• If "B.E.S.T." is set to "ON" (default setting: pg.
31), this VCR checks the tape condition for
about seven seconds, then starts recording.
(This means that the first seven seconds of the
program will not be recorded.) If this is
inconvenient for you, follow the steps below:
b
–
To pause recording
a
–
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
To stop recording
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ) on the Remote (or turn the SHUTTLE
ring on the front panel to the left).
To fast-forward the tape (when it is not running)
Press FF ( ¡ ) on the Remote (or turn the SHUTTLE
ring on the front panel to the right).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette with the VCR turned off.
To turn off the VCR
Press
or
(SP/EP) to set the recording speed.
Press REC ( ¶ ) and PAUSE ( 8 ) to start
B.E.S.T.
Then press PLAY ( 3 ) to start recording
after B.E.S.T. is complete.
.
17
EN