Table of Contents
Advertisement
Stopping the engine
While the engine is idling, remove the engine cutoff cap
o
(tether) or press the emergency-stop button.
BREAK-IN PERIOD
Engine
A break-in period of 10 to 15 hours is essential before
using the vehicle at full power.
During the break-in period, the throttle control should not be
turned more than ¾ of its range. However, occasional periods
of brief, brisk acceleration and frequent speed variations
contribute to a good break-in. On the other hand, periods of
long, high acceleration, sustained high speed and engine
overheating are harmful during the break-in period.
Belt
A new drive belt must be submitted to a 5-hour break-in period.
Avoid high-speed driving and brisk accelerations during this
period.
Inspection – 10 hours
A general inspection is recommended after the first 10 hours of
use. This inspection must be carried out by an authorized
SNOW HAWK ™ dealer.
l NOTICE:
Most of the wear in this product occurs during the break-in
o
period.
Bolts and nuts can easily become loose in a new machine.
o
Make sure you check them regularly during this period.
REMOVAL
OF
MODULE AND BELLY PAN)
In order to work on the vehicle more easily and to access the
anchor ties, we suggest that you remove the rear module from
the vehicle. To do so, you must first remove the hood. Proceed
as follows:
Disconnect the front headlight.
o
Unhook the 4 rubber latches (2 / side).
o
Remove the hood.
o
t t CAUTION
THE
SHELL
(HOOD,
REAR
GENERAL INSTRUCTIONS 1 - 5
Advertisement
Table of Contents
