Readouts - Martin Professional MAC 2000 Profile II User Manual

If tracking mode movement is not satisfactory there are 2 parameters that can be adjusted. The first is selected under
P E R S / T R A C / M O d E
positions at a steady rate. Begin by selecting the alternative,
significantly from the line of travel.
The second parameter is the number of position updates used to calculate speed. The level is adjustable between 1 and
10 under P E R S / T R A C / C A L
calculated, making movement smoother but less responsive to sudden changes. Experiment for best results.
Display
The display intensity (
whether the display remains on or extinguishes two minutes after the last key-press. To flip the display, press [Up] and
[Down] simultaneously.
Lamp
There are two settings that modify lamp control: Automatic Lamp On (
When A L ON
on, the lamp strikes automatically after the fixture is powered on. When
automatically when the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.
A L O N
When
striking at once. The delay is determined by the fixture address.
If striking lamps from the controller, note that striking many lamps at once may cause a voltage drop large enough to
prevent lamps from striking or trip the main circuit breaker. Avoid this by programming a "lamp on" sequence that
strikes lamps one at a time at 5 second intervals.
Power to the lamp can be turned off from the controller if DMX Lamp Off (
lamp off command is executed only if position 7 is selected on the color wheel and gobo 5 is selected on both gobo
wheels. Be careful: with the magnetic ballast model, it is not possible to restrike the lamp until it has cooled for a few
minutes. (The electronic ballast model provides hot restrike.)
DMX reset
The fixture can be reset from the controller if DMX reset (
command can only be executed if position 7 is selected on the color wheel and gobo 5 is selected on both gobo wheels.
Custom settings
The custom configuration function allows you to save and recall three sets of fixture settings. The savable settings are
DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp off and reset, display settings, shortcuts, studio
mode, automatic lamp on, effects feedback, tracking algorithm, and tracking samples.

Readouts

Note: The MP-2 Uploader provides commands to display the time, temperature, and version readouts on the fixture
control panel.
Time
IN FO / TI M E
each item is a resettable (
since fabrication (
be done remotely using the MP-2 Uploader.)
Temperature
IN FO / TE M P
14
. The default,
. Increasing the number of samples increases the distance over which speed is
d I N T ) setting controls display brightness. The display on/off setting (
is off, the lamp remains off until a "lamp on" command is received from the controller. When
O N D M X
is set to either or
provides readouts of fixture hours (
R S E T
) increment counter and a non-resettable counter for total accumulated hours/strikes
T O TL ). To reset an increment counter, display it and then press [Up] until it reads 0. (This may also
provides readouts of the head, base and lamp temperature in Celsius and Fahrenheit.
MAC 2000 Profile II
M O d 1 , is the best choice with controllers that calculate intermediate
MO d 2 , which is better if the intermediate positions stray
AL ON
, the automatic lamp strike timing is staggered to prevent all lamps from
P E R S / d R E S
H RS ), lamp hours (
d I S P
) and DMX Lamp Off ( DL oF
A L O N is set to D M X , the lamp strikes
d L O F ) is on. If d L O F
) is ON. If DMX reset is OFF, the reset
L HR ), and lamp strikes ( L ST
) determines
).
A LO N is
is off, a DMX
). Under