Cable Removal; Cable Connection Warning; Maintenance - Metrologic MS3780 Fusion Installation And User Manual

Introduction

Maintenance

Smudges and dirt can interfere with the proper scanning of a bar code.
Therefore, the output window will need occasional cleaning.
1. Spray glass cleaner onto a lint free, non-abrasive cleaning cloth.
2. Gently wipe the scanner window.

Cable Removal

Disconnect the power supply from the PowerLink cable and turn off power to the
host system before removing the cable from the scanner.
1. Locate the small 'pin-hole' beneath
the Fusion logo on the front side of
the scanner near the end of the
handle.
2. Bend an ordinary paperclip into the
shape shown above.
3. Insert the paperclip (or other small
metallic pin) into the small 'pin-hole'.
There will be a faint 'click' when the
connector's lock releases.
4. Pull gently on the cable's strain-relief
to remove the cable.

Cable Connection Warning

Important: If the PowerLink cable is not fully latched the unit can power
6
intermittently.
Figure 5.
Figure 4.
Figure 6.