Installing Your New Recorder; Basic Connections - JVC HR-S5700AM Instructions Manual

4
EN
Basic
Connections
Aerial terminal
Back of TV
AV-IN terminals
AV Cable
(not provided)
Mains Power
Cord
AUDIO OUT/
Mains outlet
VIDEO OUT
Connect the power plug to an AC
outlet before installing the lithium
battery.
RF Cable
(provided)
TV Aerial
Cable
Rear View
pg. 7

INSTALLING YOUR NEW RECORDER

It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" (
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
The connection method you use depends on the type
of TV you have.
RF CONNECTION
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and
the TV's aerial terminal.
AV CONNECTION
To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per "RF
CONNECTION".
b– Connect an optional AV cable between the
AUDIO OUT and VIDEO OUT connectors on the
rear panel of the recorder and the TV's AV-IN
terminals .
CONNECT RECORDER TO
MAINS
4
Plug the end of the mains power cord into a mains
outlet.
NOTE:
Use the conversion plug (not provided in certain areas)
depending on the type of your AC wall outlet.
ATTENTION
If you have finished all the necessary connections, go to
"Video Channel Set" on page 6, then perform Auto Set Up on
page 8; do NOT press the
control to turn on the recorder's power before you start Auto
Set Up.
pg. 57).
button on the recorder/remote