JVC HR-S5700AM Instructions Manual page 27

1
NUMBER
4
7
STOP+/–
1
PROG
Satellite Tuner Users
To timer-record a satellite broadcast using the G-
system:
1
Perform steps 1 – 6.
2
Set the satellite tuner to the appropriate channel before
the selected programme begins.
3
Leave the satellite tuner's power on.
2 3
2
5 6
WEEKLY
8 9
4
0
OK
PUSH JOG
CODE
RETURN TO NORMAL
SCREEN
5
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears.
Repeat steps 1 – 5 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
6
Press ‰ ‰ ‰ ‰ ‰ . The recorder turns off automatically and "‰"
appears on the display panel.
To disengage the timer, press ‰ ‰ ‰ ‰ ‰ again.
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays this
way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes ( pg. 30).
It is not possible to timer-record a TV programme with a
G- number which starts with "0".
CODE
ATTENTION
Regarding Guide Program Number Set
"G-CODE/SHOWVIEW SETUP" appears after performing
step 3 if the Guide Program number for the G-
you entered has not been set.
Press the NUMBER keys or PUSH JOG %fi to input the
channel position number on which your recorder
receives that station, then press OK or PUSH JOG
The G- program screen appears.
CODE
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2 – –
[0-9] OR [5/ ∞ ]:SELECT =
[PROG] : EXIT
27
EN
number
CODE
.
(Ex.) To timer-record a RTR
programme with the G-
CODE
system.
* If your recorder receives
RTR on the channel position
2, press OK or PUSH JOG
after entering "2".