Edit From A Camcorder - JVC HR-S5700AM Instructions Manual

40
EN
Edit From
A Camcorder
1
4
7
NUMBER "0"
1
NOTES:
All necessary cables can be obtained from your dealer.
You can also use another video recorder as the player instead
of a camcorder.
When you select "EDIT" to dub tapes, be sure to select
"AUTO" (or "NORM" when the B.E.S.T. function is set to
"OFF") after you finish dubbing the tapes (
IMPORTANT:
To edit, both the player and the recorder must be of the
same colour system. Press your recorder's COLOUR
SYSTEM button to select the appropriate colour system.
PAL, SECAM and NTSC camcorders can be used as a
player for editing.
For more information on multi-system compatibility,
pg. 44.
A If the camcorder has no S-VIDEO output connector...
PR+
PR–
VIDEO
AUDIO
input
input
Audio/Video Cable
(not provided)
VIDEO OUT
Player
Camcorder
AUDIO OUT
EDIT
2 3
2
5 6
8 9
4
0
PR +/–
pg. 15).
Recorder
To rear panel PAUSE
connector
Mini-Plug Cable
(not provided)
(JVC camcorder
only)
You can use a camcorder as the source player and your video
recorder as the recorder.
MAKE CONNECTIONS
1
A If the camcorder has no S-VIDEO output connector...
... connect the camcorder's AUDIO/VIDEO OUT
connectors to the recorder's front panel AUDIO/
VIDEO input connectors.
B If the camcorder has an S-VIDEO output connector...
... connect the camcorder's S-VIDEO OUT and
AUDIO OUT connectors to the recorder's front
panel S-VIDEO(S-2) and AUDIO input connectors.
The recorder's rear panel S-VIDEO IN and AUDIO
IN input connectors are also available.
When using a monaural camcorder, connect its
AUDIO OUT connector to the AUDIO L input
connector on your recorder.
When a Master Edit Control-equipped JVC camcorder
is used, the camcorder is capable of controlling the
recorder. Refer to the camcorder's instruction manual
for operating procedure.
SET RECORDER'S INPUT MODE
2
Press NUMBER key "0" and/or PR +/– to select "F-1"
for the AUDIO/VIDEO input connectors, or "S-2" for the
AUDIO/S-VIDEO input connectors, depending on the
connectors being used.
SELECT "EDIT" FOR PICTURE
CONTROL SET MODE
3
Follow the "Picture Control" section on page 15, then
select "EDIT."
START CAMCORDER
4
Engage its Play mode.
START RECORDER
5
Engage its Record mode.
B If the camcorder has an S-VIDEO output connector...
PR+
PR–
AUDIO
S-VIDEO
input
(S-2)
input
Audio Cable (not provided)
S-Video Cable (provided)
S-VIDEO OUT
Player
Camcorder
AUDIO OUT
EDIT
EDITING (cont.)
Recorder
To rear panel PAUSE
connector
Mini-Plug Cable
(not provided)
(JVC camcorder
only)