Introduction - Brant Radiant Heaters HLV Series Instructions For Intallation

HLV Series
1.0

Introduction

Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of the tube heater vacuum system. You must read, and understand, the instructions and
safety warnings in this manual before installing the heating system.
System Components*
Prior to installation, verify that the heater's gas type and voltage (as listed on the rating plate) match that of
your application. Also verify that you have received all heater contents included with your system by
checking them against the packing list. Materials not included in the heater kit contents (e.g., screws, vent
material, terminals, etc.) are the responsibility of the installer. Notify your product representative or Brant
Radiant Heaters Ltd of any discrepancy or missing kit contents prior to installing unit.
Figure 1.1 • Typical System Components*
* Each HLV Series vacuum system
is engineered specific to each
application's design parameters.
Some items illustrated may not be
required with your system.
Chain Set
Turnbuckle.
Burner Control Box
16" Burner Tube
Type 1 Rubber Hose
Reflector Center
Tube Hanger
Reflector
Tension Spring
Reflector End
Cap w/Clips
Tube Clamp
Ignitor/
Sensor Box
1.0 Introduction
Standard
Support
Reflector
Isolation Boot
Damper
Refer to pages 50-51 for a complete parts breakdown.
3
• Overview • System Components
Primary/Secondary
Combustion Chamber(s)
Vacuum Pump
Radiant
Tube(s)
Baffles