Replacing Bend Speed Reducer - Invacare Comet Service Manual

6.12

Replacing bend speed reducer

CAUTION! Accident hazard.
• Secure the scooter against rolling away.
NOTE:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Requirements:
•
Phillips screwdriver
• Open spanner, 32 mm.
•
Remove the seat.
•
Remove motor cover.
•
Separate battery cable.
•
Remove front and rear steering column
cladding, steering column and housing. (See
chapter entitled "Replacing steering
column").
•
Replacing sensors (5) without mounting:
•
Loosen screws.
•
Replace sensor.
•
Replacing sensors (5) with mounting:
• Loosen fork bolt (1).
• Replace sensors (5) with mounting:
• Replacing regulating unit (4):
•
Loosen screws.
•
Remove sensor (5).
•
Loosen screws (3).
•
Replace regulating unit (4).
41