Replacing Brake Cable - Invacare Comet Service Manual

6.8

Replacing brake cable

CAUTION! Accident hazard.
• Secure the scooter against rolling away.
NOTE:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Requirements:
•
Open spanner, 10 mm.
•
Phillips screwdriver
•
Decrease the brake tension on the wheel
using the setting screw (1).
•
Disconnect the brake cable at the wheel (2).
•
Disconnect brake cable at steering wheel
brake lever.
•
Route the brake cable through the cladding.
•
Loosen brake lever screw (3) at wheel.
•
Replace brake cable.
•
Reassembly of the brake cable takes place
in reverse order.
• Check braking function while pushing.
34