Editing - JVC HR-P110AG Instructions Manual

14
NOTES:
The B.E.S.T. system works only after a tape
has been inserted and the Record mode is
first initiated. It does not work during
recording.
Once the cassette is ejected, the B.E.S.T.
data is cancelled.
The next time the cassette is used for
recording, B.E.S.T. is re-performed.
ATTENTION:
Since the B.E.S.T. system works before
recording actually starts, there is a delay
of approximately 7 seconds after
on the remote are pressed, or
$
the player is pressed.
To make sure you record the desired
scene or programme in its entirely, first
perform the following steps:
1 Press and hold
Record Pause mode.
• The player then automatically check
the condition of the tape and, after
approximately 7 seconds, reenters
Record Pause.
2 Press to start recording.
$
• If you want to bypass the B.E.S.T.
system and begin recording
immediately, set "B.E.S.T." to "OFF".
Playback
The video cassette player assesses the quality
of the tape once you initiate playback.
When watching a tape recorded with
B.E.S.T. set to on, it is recommended that
you leave B.E.S.T. on during playback as
well.
The player adjusts the playback picture
8
quality based on the quality of the tape
in use.
B.E.S.T. is active during Auto Tracking.
8
NOTE:
When watching a rental tape, or one
recorded on another video player, set
B.E.S.T. to on or off to your preference.
and
7
on
7
and to engage the
9 7

Editing

Editing To/From Another Recorder
Player
Recorder
TV
Receiver
A
Connect the player's AUDIO and VIDEO
OUT connectors to the recorder's
AUDIO and VIDEO IN connectors.
B
Put the player in the Play mode.
C
Put the recorder in the Record mode.
NOTES:
NTSC tapes being played back in the NTSC
PLAYBACK ON PAL TV mode cannot be dubbed
to another recorder.
When you dub an NTSC tape using your recorder
as the playback deck, select NTSC 3.58 (or 4.43)
with the Colour System Output switch.
Important:
To edit, both the player and the
8
recorder must be of the same colour
system. Set "NTSC "to appropriate
mode. (See "Mode set"
Editing
IN OUT
ANT.IN
AUDIO
VIDEO
RF OUT
Audio/Video signals
IN OUT
ANT.IN
AUDIO
VIDEO
RF OUT
VIDEO
CHANNEL
pg. 9)