Canon PIXMA mini260 Photo Printing Manual page 94

3
Install the ink tank
4
Align the Print Head
fj
Insert the ink tank at a slant.
r-----H-ead-ali9nm;nt-requ-ir-;d~--------1
Set 2
shee~s
of paper
I
and press
C!lKJ.
j
I
I
~."~~.~
The pattern is printed and the Print Head is aligned
automatically.
fj
When the message requesting head alignment is displayed on
the LCD, press the OK button.
o
Load two sheets of the supplied 4" x 6" paper into the Auto
Sheet Feeder with the whiter side facing front. Align the paper
with the right side of the Auto Sheet Feeder, then slide the
Paper Guide toward the left edge of the paper.
Electrical Contacts
Ink Ports
Align the mark .. on the ink tank
and the mark T on the printer.
~
Important
If the lamp does not light red after it is inserted, repeat steps 2 and 3.
~
Important
Do not touch the electrical contacts and the ink ports.
€)
Press the
8
mark on the ink tank until it clicks into place and
then its lamp lights red.
o
Open the Printer Cover slightly, pull the Lock Lever to unlock,
and then close the Printer Cover.
Lock Lever
o
Remove the orange protective cap and discard it.
Protective Cap
~
Important
Once you have installed the ink tank, wait for about 90 seconds until the printer
has stopped making operating noises, before proceeding.
WNote
An error message will be displayed on the LCD if the lock lever is not set properly or the
ink tank is not installed properly. Open the Printer Cover and make sure that the lock
lever is set properly or ink tank is installed properly.
-
WNote
• The pattern is printed in black and blue.
• Print Head alignment will take about 3 minutes to complete. Do not start another
operation here.
• If the Auto Head alignment cannot be executed correctly and a message is displayed
on the LCD, please refer to "Error Message Is Displayed on the LCD" in the Photo
Printing Guide.
Hardware setup and Print Head alignment is complete.
If you are connecting the printer to a computer, please see the back side of
this sheet for Software Installation Instructions.