Canon PIXMA mini260 Photo Printing Manual page 58

Cause Action
Printer detected ink out Ink has run out. (The lamp on the ink tank flashes.)
condition of the following ink.
Replace the ink tank and close the Printer Cover.
Replace the ink tank.
Printing under the current condition may damage the printer.
U170
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level. Press
and hold the Stop/Reset button for at least 5 seconds, and then
release it.
* With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that Canon
shall not be liable for any malfunction or trouble which may be
caused by continuation of printing under the ink out condition.
The remaining level of the The remaining ink level cannot be correctly detected.
following ink cannot be correctly
Replace the ink tank and close the Printer Cover.
detected. Replace the ink tank.
Printing with an ink tank that was once empty may damage the
U180
printer.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level. Press
and hold the Stop/Reset button for at least 5 seconds, and then
release it.
* With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that Canon
shall not be liable for any printer malfunction or damage caused
by refilled ink tank.
Print head is not installed. Follow the directions given in the Easy Setup Instructions (Setup
Install the print head.
I
The type
Sheet) to install the Print Head.
of print head is incorrect.
If the Print Head is already installed, remove the Print Head and
Install the correct print head.
then reinstall it. If the error is not resolved, the Print Head may be
damaged. Contact your Canon Service representative.
The ink absorber is almost full. The printer has a built-in ink absorber to hold the ink used during
Press OK to continue printing.
Print Head Cleaning, for example.
Contact the service center.
This error message indicates that the ink absorber is nearly full.
Press the OK button to cancel the error so you can continue
printing.
However, because printing is disabled once the ink absorber
becomes completely full and until the ink absorber is replaced,
you are recommended to contact a Canon service representative
as early as possible (You will need to replace a particular part of
the printer).
The following ink tank cannot be • The ink tank is not compatible with this printer. (The lamp on the
recognized. ink tank is off.)
U140
Install an appropriate ink tank.
U150
See "Replacing an Ink Tank" on page 47.
• An Ink tank error has occurred. (The lamp on the ink tank is off.)
Replace the ink tank.
See "Replacing an Ink Tank" on page 47.
56 Troubleshooting