Table of Contents
Advertisement
4. PREPARE THE INSTALLATION
4.3 M
S
OUNTING
PACE
The mounting surface must be able to support the
cabinet load, in addition to the added weight of this
46 lb. product, plus additional oven loads of up to
50 lb. for a total weight of 96 lb.
• The space between the cabinets must be at least 30" wide and
free of obstructions.
• This microwave oven is for installation over ranges up to 36" wide.
• If you are going to vent your microwave oven to the outside, see
"Select Installation Type" Section on page 11 for exhaust duct
preparation.
• When installing the microwave oven, be careful to follow the
instructions on the top cabinet template for power cord clearance.
*Electric range: 30"
Gas range: 36½"
5. PLACEMENT OF THE MOUNTING PLATE
5.1 R
M
EMOVING
ICROWAVE
1. Remove the adapter/damper, fi lters, turntable,
roller guide ring and parts bag. Do not remove
the polystyrene protecting the front of the oven.
2. Fold back all 4 carton fl aps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the polystyrene.
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
5. Remove the 2 mounting plate retaining screws
and discard. Set the mounting plate aside.
WARNING
!
O
C
VEN FROM
ARTON
(
'
)
CONT
D
16½"
MH0001A
/R
M
EMOVING
OUNTING
P
OLYSTYRENE
MR0009A
S
CREW
M
OUNTING PLATE
MO0011A
8
M
INIMUM DISTANCE
TO COOKTOP
P
LATE
C
S
CREW
*
ARTON
Advertisement
Table of Contents
