Table of Contents
Advertisement
7. VERTICAL DISCHARGE
7.1 A
M
TTACH THE
OUNTING
Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud.
1. Remove the rear wall template and discard.
2. Remove the toggle wings from the bolts.
3. Insert the bolts into the mounting plate through the holes
designated to go into drywall and reattach the toggle
wings to 3/4" onto each bolt.
4. Place the bottom of the mounting plate against the
horizontal line on the wall (previously drawn in step 5.4 )
and insert the toggle wings into the holes in the wall to
mount the plate.
5. Tighten the wood screw and all bolts.
Be careful to avoid pinching fi ngers between
the back of the mounting plate and the wall.
7.2 P
T
C
REPARE
OP
ABINET
You need to drill holes for the top support screws, a hole large enough for the power cord to fi t through and a cutout
large enough for the adapter/damper.
Wear safety goggles when drilling holes in the
cabinet bottom.
1. Read the instructions on the top cabinet template.
2. Tape it underneath the top cabinet.
3. Drill the holes following the instructions on the template.
4. Remove the template and discard.
7.3 I
A
NSTALL
DAPTER
1. Slide adapter/damper as shown beside.
NOTE: Ensure that the damper hinge is oriented toward the
back of the microwave oven.
2. Ensure tape securing damper is removed and damper
pivots easily before mouting microwave oven.
(
CONT
P
W
LATE TO THE
WARNING
!
WARNING
!
/D
AMPER
'
)
D
ALL
MO0012
M
OUNTING
PLATE
MO0013A
MR0011
MO0014
12
S
PACING FOR TOGGLES
MORE THAN WALL THICKNESS
T
OGGLE WINGS
T
OGGLE
BOLT
W
ALL
B
OLT END
Advertisement
Table of Contents
