Table of Contents
Advertisement
9. HORIZONTAL DISCHARGE (
9.2 A
M
TTACH THE
OUNTING
Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud.
1. Remove the rear wall template and discard.
2. Remove the toggle wings from the bolts.
3. Insert the bolts into the mounting plate through the holes
designated to go into drywall and reattach the toggle
wings to 3/4" onto each bolt.
4. Place the bottom of the mounting plate against the
horizontal line on the wall (previously drawn in step 5.4 )
and insert the toggle wings into the holes in the wall to
mount the plate.
5. Tighten the wood screw and all bolts.
!
Be careful to avoid pinching fi ngers between
the back of the mounting plate and the wall.
9.3 P
T
C
REPARE
OP
ABINET
You need to drill holes for the top support screws and a hole large enough for the power cord to fi t through.
!
Wear safety goggles when drilling holes in the
cabinet bottom.
1. Read the instructions on the top cabinet template.
2. Tape it underneath the top cabinet.
3. Drill the holes following the instructions on the template.
4. Remove the template and discard.
9.4 A
B
DJUST
LOWER
1. Remove and set aside the 2 blower plate retaining
screws.
2. Lift up the blower plate.
P
W
LATE TO THE
ALL
WARNING
WARNING
'
)
CONT
D
MO0012
T
M
OUNTING
PLATE
W
MO0013A
MR0011
S
CREW
MD0008A
19
S
PACING FOR TOGGLES
MORE THAN WALL THICKNESS
OGGLE WINGS
T
OGGLE
BOLT
ALL
B
OLT END
B
LOWER PLATE
M
ICROWAVE TOP
M
ICROWAVE BACK
S
CREW
Advertisement
Table of Contents
