Table of Contents
Advertisement
9. HORIZONTAL DISCHARGE
9.4 A
B
DJUST
LOWER
7. Reinstall the blower plate with its top screw only.
8. Attach the adapter/damper to the rear of the oven by
sliding it into the guides at the top center of the back of
the oven.
NOTE: Push in securely until it is in the lower locking tabs.
Ensure that the damper hinge is located on top
and that the damper swings freely.
9. Reinstall the blower plate back screw.
10. Seal the joint with metal foil duct tape.
9.5 M
M
OUNT THE
ICROWAVE
WARNING
!
For easier installation and personal
safety, this unit must be installed by two
people.
WARNING
!
Do not grip or use door handle during
installation.
NOTES: • If your cabinet is metal, install the nylon strip around the power cord hole to prevent cutting of the cord.
• We recommend using fi ller blocks if the cabinet front hangs below the cabinet bottom shelf.
If fi ller blocks are not used, case damage may occur from over tightening screws.
• When mounting the microwave oven, thread power cord through hole in bottom of top cabinet (A). Keep
it tight throughout steps 1-3. Do not pinch cord or lift oven by pulling cord.
1. Remove the polystyrene packaging and discard.
2. Run the house duct to the microwave oven
location.
3. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate (B).
4. Rotate front of oven (C) up against cabinet bottom.
NOTE: Ensure adapter/damper is properly inserted
in your house exhaust duct after the
microwave oven is installed.
(
'
)
CONT
D
O
VEN
(
'
)
CONT
D
A
DAPTER
G
UIDE
MD0015A
MO0015
CAUTION
A
C
MO0016
21
/D
AMPER
M
ICROWAVE BACK
G
UIDE
L
OCKING TABS
B
Advertisement
Table of Contents
