7. VERTICAL DISCHARGE
7.4 M
M
OUNT THE
ICROWAVE
!
WARNING
For easier installation and personal
safety, this unit must be installed by two
people.
WARNING
!
Do not grip or use door handle during
installation.
NOTES: • If your cabinet is metal, install the nylon strip around the power cord hole to prevent cutting of the cord.
• We recommend using fi ller blocks if the cabinet front hangs below the cabinet bottom shelf.
If fi ller blocks are not used, case damage may occur from over tightening screws.
• When mounting the microwave oven, thread power cord through hole in bottom of top cabinet (A). Keep
it tight throughout steps 1-3. Do not pinch cord or lift oven by pulling cord.
1. Remove the polystyrene packaging and discard.
2. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate (B).
3. Rotate front of oven (C) up against cabinet bottom.
3. Insert 2 self-aligning screws (D) through top
cabinet holes. Temporarily secure the oven by
turning the screws at least 2 full turns on each
screw after the threads have engaged. Ensure
to keep power cord tight. Be careful not to
pinch the cord, especially when mounting
fl ush to bottom of cabinet.
(
'
)
CONT
D
O
VEN
MO0015
CAUTION
C
MO0016
13
A
MO0018
B
D