Table of Contents
Advertisement
5. PLACEMENT OF THE MOUNTING PLATE
5.3 D
M
ETERMINING
OUNTING
R
ECESSED BOTTOM CABINET
WITH FRONT OVERHANG
1. Measure the inside depth of the front
overhang.
2. Draw a horizontal line on the back wall an
equal distance below the cabinet bottom as
the inside depth of the front overhang.
3. Draw a vertical line on the wall at the center
of the 30" minimum wide space.
4. Align the top of the rear wall template with
the horizontal line and tape it onto the wall
matching the centerline.
*Electric range: 30"
Gas range: 36½"
5.4 A
M
LIGNING THE
OUNTING
Wear safety gloves as the edges of the mounting plate are sharp.
H
ORIZONTAL LINE
MD0007A
1. Draw a horizontal line on the wall at the bottom of the rear wall template.
2. Drill 5/8" holes for toggle bolts on 3 locations (Hole A, B, C) but if the location of hole is same as that of stud, drill
a 3/16" hole for wood screw. In other words, toggle bolt can not be used to the location of stud. Do not mount
the plate at this time.
NOTE: Holes A, B and C are inside area E. If none of A, B or C is in a stud, fi nd a stud somewhere in area E and
draw a fourth circle to line up with the stud. It is important to use at least one wood screw mounted fi rmly in
a stud to support the weight of the microwave oven. Set the mounting plate aside.
P
L
(
LATE
OCATION
CONT
MD0006A
P
LATE
WARNING
!
C
ENTERLINE
A
NOTCH
A
E
C
REA
10
(
CONT
'
)
D
P
LATE POSITION BENEATH RECESSED
BOTTOM CABINET WITH FRONT OVERHANG
C L
D
RAW A HORIZONTAL LINE
ON WALL FROM BOTTOM OF
THE REAR WALL TEMPLATE
'
)
D
D
RAW A HORIZONTAL LINE
ON THE BACK WALL
EQUAL TO THE DEPTH
.
OF THE FRONT OVERHANG
M
INIMUM DISTANCE
TO COOKTOP
B
H
ORIZONTAL LINE
*
Advertisement
Table of Contents
