Foscam FI8918W User Manual page 43

Enable Set Filename: When you enable this option the uploaded image will be named
according to the filename you enter. The next image will overwrite the filename of the previous
image. Hence there will only be one image, the last uploaded.
Filename: See the above option.
Note: You cannot change the name of the alarm image.
Upload Interval refers to the time between the current image and the next image being
uploaded.
Click Submit to save these settings. Click Test, the following screen displays if successful.
The following errors may occur:
1) Can not connect to the server. Check if the FTP Server is correct.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password. Check the username and password.
5) Cannot access the folder. Verify the folder exists and your account is authorized
6) Error in PASV mode. Verify the server supports PASV mode.
7) Error in PORT mode. PASV mode should be selected if the device is behind a NAT.
8) Cannot upload file. Verify your account is authorized
If an error occurs check the parameters you entered are correct. The filename format of the
image is similar to 00606E8C1930(sarah)_0_20100728114350_25.jpg
Check if your FTP server supports this file name format.
Shenzhen Foscam Intelligent
Shenzhen Foscam Intelligent
Tel: 86 755 2674 5668 Fax:
Tel: 86 755 2674 5668 Fax:
Figure 3.38
Technology Co., Limited
Technology Co., Limited
86 755 2674 5168
86 755 2674 5168
w ww.foscam.co m
w ww.foscam.co m
40