Wireless Settings - Foscam FI8918W User Manual

Http Port: The default Lan port is 80.You can set another port number, such as port 8005,
8100.etc.
User&Password: Default administrator user name is admin with no password.
NOTE:
If the prompt "Subnet doesn't match, dbclick to change!" appears, please enable DHCP set
camera's IP address and gateway once again.

3.7 Wireless Settings

Wireless Lan Settings support three modes: Infra(Do wireless lan settings manually) and WPS
(Wi-FI Protected Set-up) and Adhoc.
If your router does not support WPS function,please go to chapter 3.7.1 and make
wireless connection settings manually.
If your router supports WPS function, please go to chapter 3.7.2 and make wireless
connection settings quickly.
If there is no wireless router, please go to chapter 3.7.3 and Connect the IPCAM directly to
a host in a peer_to_peer environment.
3.7.1 Infrastructure Mode
Step 01) Please choose "Device Management" and goes to the option Wireless LAN
Settings , click "Wireless LAN Settings". Then enable "Using Wireless LAN".
Click the Scan button and the camera will detect all WIFI devices around the area. It should also
display your router in the list. (Figure 3.19)
Step 02) Click the SSID of your router in the list, the corresponding information (SSID &
Shenzhen Foscam Intelligent
Shenzhen Foscam Intelligent
Tel: 86 755 2674 5668 Fax:
Tel: 86 755 2674 5668 Fax:
Figure 3.19
Technology Co., Limited
Technology Co., Limited
86 755 2674 5168
86 755 2674 5168
Click Scan Button to search WIFI
device .
w ww.foscam.co m
w ww.foscam.co m
26