Advertisement
Check points before calling your service provider
Problem
Is the electric power connected
nothing on the LCD display
properly for AC adapter and behind
panel
of the main body?
Only the center of the operation
indicator (diffusion of waterdrop)
Did you press the "START" button?
is blinking.
White bubbles does not rise
Did you put catalysis?
in the water!
Is it ringing for 1 min. at 30 sec.
Why does "beep" sound keep
intervals, after the completion of the
ringing?
production?
I pressed the start button again,
Did you press the start button again
but only the container indicator
for the already-manufactured water?
is blinking without the operation.
Operation indicator, container
indicator, and stand-by indicator
Did you put too much catalysis?
are blinking fast with "beep-beep"
sound.
Check points
Put the plug into the socket and connect the adapter to the main
body properly.
It's normal. When the electrolysis is completed, only the center of the
operation indicator (diffusion of waterdrop) is blinking.
Oxygen, hydrogen, and chlorine gas are created during the electrolysis.
Only when the catalysis reacts with the gases, white bubbles rise and
electrolysis water is created.
For the normal process, production using electrolysis is completed in
1 min. 30sec. after pressing the start button. The "beep" sound indicates
the completion of the production and rings twice at 30 sec. intervals.
Therefore, you just need to use it as sterilizing water or washing water
after the beep sound.
After the operation is completed and electrolysis water is made, the
device is not reoperating due to the safety reason.
(You can just use the water.)
Standard capacity for spray container (600mL) is one measuring spoon
(1g), and that for large container (1,200mL) is one and half measuring
spoon. If the capacity is exceeded, it is designed not to operate due to
the safety reason. When you put too much catalysis comparing with
water volume, please discard the water, fill new water, add proper
amount of catalysis, and then operate the device again.
Solution
Advertisement
