Preset Download - JVC HR-J268EU Instructions Manual

6
EN
Preset
Download
You can use this function only with the TV offering
T-V Link, etc.*
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-
wired 21-pin SCART cable. The degree of compatibility and
available functions may differ by system.
1
4
7
1
NOTES:
In the area where no TV station transmits a PDC signal, the
recorder can perform neither auto clock set nor auto Guide
Program number set.
If there is a power cut, or if you press
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from the
beginning.
Auto clock may not function properly depending on the
reception condition.
When you perform T-V LINK function, be sure to use fully-
wired 21-pin SCART cable.
On this recorder, the characters available for station's name
*
(ID) are A–Z, 0–9, –,
station's name may differ from those of your TV (
2 3
2
5 6
8 9
0
4
?
OK
or MENU while
, + and (space). Some downloaded
When you connect the recorder and your TV via fully-wired
21-pin SCART cable (
channels by downloading preset data from your TV instead of
using the Auto Set Up function (
completed, the recorder sets the clock and Guide Program
number automatically. For details, refer to the instruction
manual for your TV.
Perform steps 1 to 3 of "Auto Set Up" on page 4 and 5 before
continuing.
PERFORM PRESET DOWNLOAD
1
Press OK.
If you are referring to the front display panel
Press % fi to select "CH – –" and press OK or
If you are referring to the on-screen display
Press % fi to move the
highlight bar (pointer) to
"T-V LINK" and press OK
#
or
Preset position on the display panel increases from
"CH1"; do NOT press any button on the recorder or
remote control until the display panel shows either
the display as illustrated on page 7 or "– –:– –".
If "– –:– –" appears on the display panel, refer to page
7.
If you are using the on-
screen display, the T-V
LINK screen will appear.
Then the GUIDE PROG
SET screen will appear
during Guide Program
number set.
If you press any button
on the recorder or
remote control while
downloading is in
progress, it will be
interrupted.
SET VIDEO CHANNEL
2
Set the Video Channel to off manually. (
pg. 39).
INITIAL SETTINGS (cont.)
pg. 3), you can set the recorder's tuner
pg. 4). After downloading is
.
[5 ∞ ] =
[MENU] : EXIT
[MENU] : EXIT
[MENU] : EXIT
#
.
AUTO SET
T-V LINK
T-V LINK
PLEASE WAIT
GUIDE PROG SET
PLEASE WAIT
pg. 44)