Download Print this page

Dux 26XL Installer's Manual

Gas continuous flow water heater

Advertisement

Quick Links

Installer's Guide
On completion, sign and leave with owner
Gas continuous flow water heater
Models:
26XL
26XN
Installation by a licensed tradesperson and in
accordance with:
• AS/NZS 3500.4 "National Plumbing &
Drainage Code Hot Water Supply Systems
– Acceptable Solutions"
• AS5601/AG601 Gas Installation
• Adherence to local authority and OH&S
regulations
• Victorian PIC Requirements
For advice, repairs and service, call:
1300 365 115 (Australia)
0800 729 389 (New Zealand)
Specifications and materials may change without notice
Effective for Endurance continuous flow water heaters manufactured and sold after 1st Sept 2009.
Part No: IG090701
Version: B
Important InFormatIon
Read This Document First

Advertisement

loading
Need help?

Need help?

Do you have a question about the 26XL and is the answer not in the manual?

Questions and answers

Summary of Contents for Dux 26XL

  • Page 1 Important InFormatIon Read This Document First On completion, sign and leave with owner Gas continuous flow water heater Models: 26XL 26XN Installation by a licensed tradesperson and in accordance with: • AS/NZS 3500.4 “National Plumbing & Drainage Code Hot Water Supply Systems –...
  • Page 2 Installer’s Guide – Endurance six™ Installation Guide Step 1 • Arrive at site, park vehicle as close as allowable to installation, and conduct a safety audit. • Safety audits can also be known as Work Method Statements (WMS) or Job Site Analysis (JSA). Note –...
  • Page 3 Installer’s Guide – Endurance six™ Installation Guide • Refer to the Owner’s Manual and AG 601 for detailed installation instructions. • Plan hot water pipework to ensure optimum flow rates to all outlets. Step 4 • Check labels located on the unit’s side for: a.
  • Page 4 Installer’s Guide – Endurance six™ Installation Guide Step 5 Water Connection • Using correct plumbing methods, connect the cold water pipe to the heater. Note: According to local regulations and the plumbing code, fit any and all valves that are necessary e.g.
  • Page 5 Installer’s Guide – Endurance six™ Installation Guide Step 7 Gas Connection • Fit a union to the water heater gas inlet for easy connection and removal. The thread diameter is R¾/20. • Fit an AGA approved isolating gas cock in the supply line adjacent to the water heater gas connection.
  • Page 6 Installer’s Guide – Endurance six™ Step 8 • This unit has a preset temperature of 50°C. • If controllers are installed, the maximum temperature setting will still be 50°C. Step 9 • Make sure there is water inside the unit prior to turning on the power. This can be achieved by turning on the tap.
  • Page 7 Installer’s Guide – Endurance six™ Installation Guide Step 11 Installation Of Main Remote Control • Detach the fitting bracket from Main Bad examples remote controller by sliding it down. • Attach the fitting plate to wall. • Install conduit inside of wall in Chemicals Do Not Main Remote Control...
  • Page 8 Installer’s Guide – Endurance six™ Installation Guide Step 12 Installation of Shower Remote Control • Drill a hole (more than diameter about 12mm) in a wall for the remote controller cables. • After passing the remote controller Shower Remote Control cables through the hole, remove Model YST-2252 the packing’s back paper of remote...
  • Page 9: Installation Declaration

    Tank Model Number: ..................... Date Installed: ......Dux Hot Water terms and conditions of warranty will only apply if the below is signed by the installer. This notifies Dux Hot Water that all the requirements of proper installation have been carried out by the installer in accordance with the Dux Hot Water Installation Commissioning Checklist and all other requirements noted in the Dux Hot Water Owner’s Manual supplied with the solar water heater.
  • Page 10 Installer’s Guide – Endurance six™ Part No: IG090701 Version: B...
  • Page 11 Installer’s Guide – Endurance six™ Part No: IG090701 Version: B...
  • Page 12 Installer’s Guide – Endurance six™ Gas continuous flow water heater Models: 26XL 26XN For advice, repairs and service, call: 1300 365 115 (Australia) 0800 729 389 (New Zealand) Part No: IG090701 Version: B...

This manual is also suitable for:

26xnEndurance six 26xlEndurance six 26xn