Spécifications Techniques - Fantom FM142EF Owner's Manual

FAMILIARISEZ-VOUS AVEC VOTRE ASPIRATEUR
BAGLESS STICK VAC
Spécifications techniques
Tension : 120V., 60Hz.
Puissance : 9,8 amps, 1 200 watts
1. Manche escamotable
2. Bouton de verrouillage
3. Pince de retenue du cordon
4. Boîtier principal
5. Manche
6. Commutateur marche/arrêt
7. Boyau flexible
8. Couvercle du filtre post-
moteur
9. Connecteur du boyau
10. Coupelle à poussière
11. Verrou de la coupelle à
poussière
12. Tubes de rallonge (2)
13. Fiche
14. Brosse à plancher
15. Suceur plat
16. Brosse à épousseter
17. Bandoulière
18. Orifices de fixation de la
bandoulière
11
OPERATING INSTRUCTIONS cont.
Attaching the Shoulder Strap
Use the hooks to attach the shoulder
strap to the vacuum cleaner.
Connect the dog leash swivel hooks
to the eyelets located near the top of
the unit handle and at the base of the
unit. Adjust the strap as required for
comfort.
Hook for Hook for
Shoulder Shoulder Strap
Strap
Warning:
After extended use, the body
of the vacuum cleaner may become hot.
When using the unit with the shoulder
strap, the unit will touch the body of the
user. Therefore make sure to use the
vacuum cleaner with the strap only when
the unit is cool. If it gets too warm, allow it
to cool before continuing to use it.
ORDERING REPLACEMENT DUST CUP FILTERS
TO ORDER REPLACEMENT FILTERS
or for Technical Support
for Model FM142EF
Call FANTOM Customer Service: 1 (800) 275-9251
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
or visit our website: www.fantom.com
Please Note:
The HEPA-TYPE Dust Cup Filter is washable. It should, however, be replaced every
six (6) months to ensure peak performance of your vacuum.
Both the Pre-Motor and Post Motor Filters are washable. They should however be
replaced every three (3) months to ensure peak performance of your vacuum.
Important:
Make sure that ALL filters have been sir dried for 24 hours before re-installing back in
the hand vacuum.
Motor Thermostat
IMPORTANT:
This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter).
• If clogged hose or filter is found,
2 unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact FANTOM customer
service at 1 800 275-9251.
8