Connecting To A Satellite Receiver - JVC HR-DVS3EU Instructions Manual

64
EN

Connecting To A Satellite Receiver

Simple Connections
This is an example of simple connection if your TV has
one 21-pin AV input (SCART) connector.
Connect the satellite receiver to the AV2 (L-2) IN/
DECODER connector, then connect the AV1 (L-1) IN/
OUT connector to the TV's connector.
Back of TV
IMPORTANT
When you set "L-2 SELECT" to "SAT" (
the recorder is in timer mode, in stop mode, in recording mode or turned off. When the recorder is in Stop mode or recording,
press TV/VCR on the remote control to turn off the VCR indicator on the front display panel.
Set "L-1 OUTPUT" to "VIDEO" and set the satellite receiver's output and the TV's input to the composite mode.
When the recorder is turned off, only a composite signal is output from the recorder to TV.
If you turn on the recorder when the satellite receiver's power is off, nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or press TV/VCR on the remote control to set the recorder to the video mode.
Aerial
connector
ANTENNA IN
ANTENNA OUT
21-pin SCART connector
ANTENNA
ANTENNE
OUT
S
IN
SORTIE
ENTREE
OUT
SORTIE
pg. 53), it is possible to view a satellite broadcast with the TV set to its AV mode even if
NOTES:
Set "L-2 SELECT" to "A/V" (
To record a programme via the satellite receiver, select L-2
mode by pressing AUX (number key "0") and/or PR so that
"L-2" appears on the front display panel.
For details, refer to the instruction manual of the satellite
receiver.
Aerial
TV aerial
cable
IN/OUT
AV1 (L-1)
ENTREE/SORTIE
AUDIO
L
OUT
SORTIE
R
SAT CONTROL
CONTROLEUR SAT
IN/DECODER
AV2 (L-2)
ENTREE/DECODEUR
SYSTEM CONNECTIONS (cont.)
pg. 53).
Outdoor unit
Satellite cable
Satellite receiver
TV VCR
Mains outlet
Back of recorder
DECODER