Elapsed Recording Time Indication; Tape Remaining Time - JVC HR-DVS3EU Instructions Manual

1
2
1 2 3
4 5 6
3
7 8 9 4
4
0
1
3
2

Elapsed Recording Time Indication

1
Set the counter display.
Press – –:– – until a counter reading appears on the front
display panel.
2
Reset the counter.
Press 0000 before starting recording or playback.
The counter is reset to "0:00:00" and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.

Tape Remaining Time

Press – –:– – until the time remaining on the tape appears
on the front display panel.
The front display panel shows the tape remaining time with
y
" " displayed.
By pressing the – –:– – button, you can change the display to
show the counter reading, channel position*, clock time or
tape remaining time.
* Channel position is not displayed during playback.
NOTE:
Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
"– –:– –" may sometimes appear, or the display may blink on
occasion.
27
EN