JVC HR-DVS3EU Instructions Manual page 85

TIMER RECORDING
SYMPTOM
1. Timer recording won't work.
2. Timer programming is not possible.
3. " " and " " on the front display
# [
panel won't stop blinking.
4. " " blinks for 10 seconds and the
#
Timer mode is disengaged.
5. The S V system does not timer-
HOW IEW
record properly.
6. " " on the front display panel and
[
SAT indicator won't stop blinking.
#
7. The power shuts off and "
stop blinking.
The clock and/or the timer have been set
incorrectly.
The timer is not engaged.
Timer recording may not work when the
recorder's input mode is set to "F-1" for
recording on the DV deck, because the
recorder is waiting for the signals
through DV IN/OUT (i.Link) connector.
Timer recording is in progress.
The timer is engaged but there's no
cassette loaded.
The end of the tape was reached during
timer recording.
VHS deck
The loaded cassette has had its record
safety tab removed.
DV deck
The loaded cassette has had its erase
protection switch set to "SAVE".
has been pressed when there are no
#
programs in memory, or the timer
record information has been
programmed incorrectly.
The recorder's channel positions have
been set incorrectly.
The end of the tape was reached during
Automatic Satellite Programme
Recording.
VHS deck
The loaded cassette has had its record
safety tab removed.
DV deck
The loaded cassette has had its erase
protection switch set to "SAVE".
" won't The end of the tape was reached during
[
Instant Timer Recording.
POSSIBLE CAUSE CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press and confirm that "
#
displayed on the front display panel.
Set the channel position other than "F-1"
before engaging to Timer-Standby mode.
Timer programming can't be performed
while a timer recording is in progress.
Wait until it finishes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the
record safety tab intact, or cover the hole
using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase
protection switch set to "REC".
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
Remove the cassette and set the erase
protection switch to "REC".
Check the programmed data and re-
program as necessary, then press
Refer to "Guide Program Number Set"
( pg. 82) and re-perform the procedure.
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
Remove the cassette and set the erase
protection switch to "REC".
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
85
EN
" is
#
again.
#