Scheduled Gps Time Updating / Arc (Automatic Regional Calibration) - Navig8r Navwatch-S10 User Manual

Manual updating
1. The first step here is the same as the first step with setting
the time zone; press and hold the MODE button until the
Day / Time zone (abbreviation) digits starts flashing
between T1 (Time Zone 1 abbreviation) and UTC.
(or a + / - number. Eg. +3 or -10)
2. Then press the FUNCTION button. The year number will start flashing. Then use
the LIGHT button to either increase or the REC button to decrease this figure.
3. Press the FUNCTION button again to move to the next field, MONTHS, and use
the same LIGHT and REC buttons to either increase or decrease this figure.
4. Repeat again to the sections DAY, HOURS, MINUTE, SECOND, then finally you
have the option to turn ON or OFF DST (Day Light Savings time) accordingly.
5. Press the MODE button until you return back to the main time menu screen.
Note: Only the time for T1 can be set manually. There is an option to adjust for daylight
savings for T2 only. This can be done by pressing the MODE after point 4 above. The T1
sign will then change to T2. Then press function to start to toggle to the DST field. Then
use the LIGHT and REC buttons to adjust, then finally the MODE button to confirm and
exit.

Scheduled GPS time updating / ARC (Automatic Regional Calibration)

1. To ensure you have accurate time for each day and in any time zone, simply set
your watch to automatically update itself at a given time each day.
2. Press the NAVIGATION button once and use the LIGHT
and REC buttons to toggle to ARC. Press the FUNCTION
button to enter this feature. ARC1 will then begin to
flash.
3. Press the FUNCTION button to begin setting up the
details for ARC1 (T1 Time Zone).
USER MANUAL
NAVWATCH-S10
9 | P a g e