Dump Box Kit (Part Nos. 835-00 & 835-01); Dump Box Operating Guidelines; Roll Bar Kit (Part No. 648-15); Accessory Outlet Kit (Part No. 633-25) - Argo 6 x 6 Vanguard Operator's Manual

11.23 DUMP BOX KIT (Part Nos. 835-00 & 835-01)
The dump box kit can be installed on any Argo 8 x 8. It im-
proves the load carrying versatility of the Argo.
Keep hands and arms clear when lowering box.
No riders in box; riders can fall off and be killed
Installation of dump box reduces vehicle capacity;
On land: 408kg (900lbs)
On water: 227kg (500lbs)
(Capacity includes: occupants, cargo and fuel)
Tie loads down. Spread loads evenly.
Operators should use caution when turning in confined
spaces and close to bystanders. The dump box decreases
the rear clearance of the Argo.
Never operate dump while moving.
Operate dump on level ground only.
The dump box decreases the vehicle stability. Operate
the vehicle with extra precautions when on uneven ter-
rain and in water.
Note: Frequent use of the powered dump box will result
in battery drain. The installation of an alternator kit is
strongly suggested.

11.23.1 Dump Box Operating Guidelines

1. For quick removal of the box disconnect the actuator or
springs then disconnect the rear hinge pins 104-32.
2. The rear side seats can still be used if you remove the
dump box and undercarriage.
3. A rear bench seat kit 849-60 can be used when the dump
box is removed. The undercarriage frame support plates
are in the same location as the rear bench seat frame sup-
port plates. So the seat can quickly be attached without
any additional mounting.

11.24 ROLL BAR KIT (Part No. 648-15)

The roll bar is designed for use on all Argo 6 x 6 models. The
roll bar provides some roll over protection and lap belts for
the driver and front seat passenger.
When the Roll Bar Kit is installed, ALWAYS wear seat
belts when operating the vehicle on land. REMOVE seat
belts when entering water.
Maximum total vehicle weight must not exceed 1465 lbs.
or 665 kg. which means 2 people and 100 lbs. or 46 kg.
of cargo in the vehicle.
SECTION 11
ACCESSORY INFORMATION
51
Never attach anything to the Roll Bar other than On-
tario Drive & Gear 648-15 Roll Bar specific accesso-
ries.
The Roll Bar reduces vehicle stability. Always use com-
mon sense when traveling over rough terrain.
The Roll Bar is designed to reduce the chance of injury.
DO NOT rely on it to protect the vehicle occupants from
irresponsible driving.
The Roll Bar could come in contact with tree branches.
Falling branches or vehicle upset could occur. Use ex-
treme caution when traveling on narrow tree lined trails.
DO NOT use the Roll Bar as an attachment point for
towing or winching.
Check the torque of the Roll Bar nuts and bolts annu-
ally and replace any parts that are damaged. When the
Roll Bar is installed, never carry more than two people
in the Argo.
Replace worn or damaged seat belt straps and buckles.
Failure to comply with the above could result in per-
sonal injury or death.
11.25 12V Accessory Outlet Kit (Part No. 633-25)
The 12V Accessory Outlet Kit contains a 12V outlet, wire
harness complete with in-line fuse holder & fuse, and the nec-
essary hardware to mount the outlet in the upper body of any
Argo model. When mounting the outlet, be sure to select an
area within reach for the wire harness. The wire harness gets
connected directly to the battery terminals so any mounting
location chosen, must allow the harness to reach both the out-
let and the battery. When mounting, be sure that the wire
harness is securely clipped into place and not left dangling
near moving parts within the engine compartment.
Because the outlet is wired directly to the battery, it is
constantly "live," even without the key turned on. Ex-
cessive use will run down the battery.
This outlet is NOT designed to support nor should it be
used as a cigarette lighter socket.